1. The electric connecting wire or the wire clamp is not enough current to be burned or broken.
2. The electric connecting wire has serious loose strands, causing the strands to be burned or the wire to be burned.
3. The electrical connection wire is corroded so badly that the cross-sectional flow surface is insufficient and the strand or wire is burned.
4. Poor contact between the electrical connection wire and the wire clamp or poor contact between the power supply wire clamp and the contact wire, causing burns.
5. Insufficient contact with current-carrying surface of wire clamps and clues causes burning.
6. The loosening of the clamp nut in a certain place was not discovered and dealt with in time, causing the electrical connector to fall off.
7. After pogo pin connector is installed, there is no temperature change offset reserved or the offset reserved too little.
8. After the pogo pin connector is installed, the reserved value of temperature change offset becomes larger, and the vertical electrical connection line between the load-bearing cable and the contact line relaxes until it relaxes to the lower part of the contact line, and the pantograph is in operation. Broken or cut off. The distance between the bottom ring of the vertical part and the contact line is too small, and it is damaged by the pantograph.
9. The skewed installation of the power supply clamp on the contact wire was knocked out by the pantograph, which resulted in a bow slashing accident.
10. A bow appears in other positions of the catenary, and the pantograph continues to operate to the place where the connector is installed, and the electrical connector is damaged.